© DY Engineering. Copyright  2012 Made with Xara Back Cover Kit for NEMA23 Square Frame Stepper Motor IP64 - Protected against water splashes A neat solution to cover the stepper motor back side providing connector interface, motor wiring protection and rear shaft (if applicable) protection. • An aesthetic solution to a common problem • Connector interface for easy maintenance and setup process • For a professional looking machine Features: • Quality made of a durable plastic • Easily mounts using the motor's existing screw holes (see installation guide  for more info) • Provides IP64 protection (subject to proper installation). • Suitable for both motors with or without rear shaft. • Incorporates a sleeve protecting the rear shaft of a motor from interfering with the wiring. • Comes with pre-drilled centre marks for fast and easy drilling of the mounting holes to suit the motor. • Each kit contains: 1 motor cover, 4 M3x25 mounting screws, 1 pg7 cable gland, 1 pre-installed O-ring seal. NOTE: If your motor frame square measures 60mm and not the usual 57mm, please check this cover. Click here to check the covers fit your motor Unit Price: 12.99 AUD